Trying to get MRTG to graph ADSL throughput of Cisco 837

[Jamie Dobbs]

I'm trying to get MRTG to graph the ADSL throughput (bps) of a Cisco837
router. I've searched but haven't been able to find a MIB that work, I
have tried:

Dialer0:public@<ip>
ATM0:public@<ip>
ATM0.1:public@<ip>

but none of these appear to return any data.
Can anyone offer any assistance?

Cheers

Jamie

[Reuben Farrelly]

Hi,

Post by Jamie Dobbs
I'm trying to get MRTG to graph the ADSL throughput (bps) of a Cisco837
router. I've searched but haven't been able to find a MIB that work, I
but none of these appear to return any data.
Can anyone offer any assistance?

Sure. This is for a 1721 but the same works on the 837.

1. Set up your SNMP community:

router(config)#snmp-server community snmpaccess RO

2. Plot the throughput of the ATM0 interface:

Target[router_ATM0]: \ATM0:***@router:
SetEnv[router_ATM0]: MRTG_INT_IP="" MRTG_INT_DESCR="ATM0"
MaxBytes[router_ATM0]: 160000
AbsMax[router_ATM0]: 256000
RouterUptime[router_ATM0]: ***@router:
Title[router_ATM0]: Traffic Analysis for ATM0 to Orcon -- router

3. I also plot the DSL linespeed:

Target[router_ADSL_LINESPEED]:
transmission.94.1.1.4.1.2.8&transmission.94.1.1.5.1.2.8:***@router

If you are doing your measurements from inside and behind the router, use the
Ethernet0 interface IP address to poll, not the outside one.

reuben

[Craig Humphrey]

Failing that, use cfgmaker. It's pretty good at figuring out interfaces...

-----Original Message-----
Sent: Sunday, June 05, 2005 2:44 PM
To: Jamie Dobbs
Subject: Re: Trying to get MRTG to graph ADSL throughput of Cisco 837
Hi,

Post by Jamie Dobbs
I'm trying to get MRTG to graph the ADSL throughput (bps) of a
Cisco837 router. I've searched but haven't been able to find a MIB
but none of these appear to return any data.
Can anyone offer any assistance?

Sure. This is for a 1721 but the same works on the 837.

[snip snip]